KOESTER AUTOMOTIVE
15315 DICKENS ST
SHERMAN OAKS, CA 91403
Tel: (818)986-7376
Cell: (818) 383-3788
Fax: (818)986-9788

KOESTER AUTOMOTIVE
Count on us for fair, friendly service!

Bleeding the Brakes

Bleeding is a service procedure that involves purging air from the master cylinder, brake lines, calipers, and wheel cylinders.

If there are air bubbles in the fluid, they will compress when the brakes are applied, causing either a low or soft pedal. Bleeding gets the air out, leaving only non-compressible brake fluid.

Air can enter lines when the system is opened for repairs. Air can also enter the lines if the master cylinder reservoir gets too low.

To remove air, bleeder screws on the calipers and/or wheel cylinders are opened one at a time. Old fluid, along with any air, is then drained, pumped, pushed or siphoned out while fresh fluid is added to the master cylinder reservoir.

Manual bleeding is usually a two-person job. One person pumps the brake pedal while another closes the bleeder screw after each stroke to prevent air from being pulled back into the system. Gravity bleeding doesn't involve any pumping. The bleeder screws are opened and the fluid is allowed to dribble out.

Gravity bleeding is slow and seldom used except on certain import applications. Most professionals use power bleeding because it is fast and does not require another person. Compressed air is used to force new brake fluid through the master cylinder to push out the old.

Another method sometimes used is vacuum bleeding. Special equipment is used to siphon old fluid out through each bleeder screw.

To get all the air out, brakes must be bled in the proper sequence. Depending on how the hydraulics are split (front/rear or diagonally), the usual sequence is to bleed the wheels furthest from the master cylinder, then the closest wheels.

On most rear-wheel drive vehicles, the recommended sequence is RR, LR, RF, LF. On front-wheel drive cars with diagonally split brake systems, the sequence is RR, LF, LR, RF.

If the master cylinder is being replaced, it may have to be bench bled before being installed.

 

 

 

 

 

 

Certifications &
Affiliations
ASA Member  ASE Brakes 
Better Business Bureau Member
State Emissions Repair
State Safety Inspection