KOESTER AUTOMOTIVE
15315 DICKENS ST
SHERMAN OAKS, CA 91403
Tel: (818)986-7376
Cell: (818) 383-3788
Fax: (818)986-9788

KOESTER AUTOMOTIVE
Count on us for fair, friendly service!

What kind of maintenance is recommended for the cooling system?

Vol. Per Cent Coolant

Boiling Point F (at 0 psig)

Freezing Point F

10

215

+25

20

217

+16

30

219

+4

40

222

-12

50

226

-34

60

231

-62

70

238

-84

80

250

-57

90

272

-33

100

330

-9

Replacing coolant on a regular basis will prolong the life of the radiator and other cooling system components. Most new car maintenance schedules call for coolant changes every three years or 50,000 miles. Many professional mechanics consider that too long and recommend every two years or 24,000 miles.

There are some who argue that annual coolant changes on late model vehicles with bimetal engines (aluminum heads/iron blocks) and/or aluminum radiators is a good idea.

It does not really make much difference how often the coolant is changed as long as it is changed before losing its corrosion resistance. Antifreeze is made of ethylene glycol (which never wears out) and various additives (which do wear out).

Some additives provide "reserve alkalinity" to neutralize internal corrosion before it can start. As long as the coolant is changed before its reserve alkalinity is depleted, the cooling system should be no worse for the wear. If you wait too long, the result can be expensive internal corrosion in the radiator, heater core and engine.

How can you tell when it is time to change the coolant? The only way to know if the coolant still has adequate corrosion protection is to test it. By dipping a test strip in the coolant and noting its color change, you can determine coolant condition and whether or not it is time to replace it.

When coolant is changed, the system should be reverse flushed rather than simply drained. This helps dislodge and remove accumulated debris and debris in the system. It also removes old coolant that would otherwise remain in the engine block.

Use of a cooling system cleaner is not necessary unless the system has been badly neglected and is full of lime deposits.

The cooling system should be refilled with a 50/50 mixture of ethylene glycol antifreeze and clean water. This provides freezing protection down to -34 degrees F and boil-over protection to 265 degrees F.

When coolant is changed, inspect belts and hoses. Make a visual inspection for leaks. Pressure test radiator and cap. Check operation of heater and defroster.

The thermostat does not need changing unless it has been causing trouble or the engine has severely overheated. If a thermostat is replaced, it should have the same temperature rating as the original. This is extremely important on late model vehicles with computerized engine controls. Fuel, ignition and emission functions are all affected by coolant temperature.

 

 

 

 

 

 

 

Certifications &
Affiliations
ASA Member  ASE Brakes 
Better Business Bureau Member
State Emissions Repair
State Safety Inspection